Worktop fabrication in Aldborough Hatch

Yes. Aldborough Hatch is on the patch, and the postcodes we work here are IG2. It is worked on our east London run, along with the rest of Redbridge. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. The bench work is about keeping enough solid material between them - a hob cut-out too near a sink cut-out leaves a narrow bridge that will not survive being lifted, so we either move the appliance positions on the template or split the run and put a join over a gable between the two cut-outs. Every join over a gable, clear of every cut-out. The older properties out here have uneven floors, so levelling the base units properly matters more than usual before any stone goes down.

Semi-rural feel with verges, unrestricted parking and generous frontages, so unloading is easy; the older cottages have low door heads and narrow openings that dictate how a slab is carried in. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. Final appliance positions and the actual sink and hob need to be settled before machining, because on a run this short a few centimetres of movement decides whether the piece can be cut in one. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.