Worktop templating in Becontree Heath

Yes. Becontree Heath is on the patch, and the postcodes we work here are RM8, RM10. It is worked on our east London run, along with the rest of Barking and Dagenham. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rear access through a garden or a shared path means long pieces can usually come in whole from the back. Concrete and dense block walls in ex-council stock cannot be chased back or packed out to suit, so the template takes the wall exactly as it is and the stone carries the scribe. Recorded as it is, not as it was drawn. The private 1930s semis here have deeper rooms than the estate houses next door, so we do not assume the standard Becontree layout when quoting.

Main roads through here are busy and junction-heavy, but the side streets have driveways, dropped kerbs and side gates, so the actual unloading is usually done off the main route. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.