Worktop installation in Cudham

Yes. Cudham is on the patch, and the postcodes we work here are TN14. It is worked on our south east London run, along with the rest of Bromley. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. What costs time is the distance from where the van can park to the door, often down a long drive or across gravel, so we plan the carry with enough hands and board the route where it crosses gravel or lawn. That is the shape of the day. On barn conversions the timber frame moves seasonally, so we mechanically isolate the stone from the structure and never bond a run tight against a post.

Single-track lanes with steep banks, mud on the road and gates that need opening; some properties are up a farm track where the last two hundred metres are unmetalled. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. The prep list is not optional.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The back edge is eased in progressively rather than offered up once and forced. Dry-lay, mark, cut, then bond. Give us the hardest, shortest approach to the door you can, clear of parked cars, and warn us of any soft ground, steps or gravel on the route. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first.