Splashbacks and upstands in Dagenham

Yes. Dagenham is on the patch, and the postcodes we work here are RM9, RM10. It is worked on our east London run, along with the rest of Barking and Dagenham. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are dense block or in-situ concrete with a bonded plaster, so the bottom course of tiles brings plaster with it when the old top comes off. That suits a full-height piece, because a large flat panel bonded across its back is more stable on concrete than a run of small tiles ever was. Cut from the same slab run as the tops. Most Dagenham jobs are about maximising continuous run length in a small room, so we plan the sink and hob positions to leave one usable stretch of at least 900mm.

Generally good, wide estate roads, front gardens, hardstanding and free parking on most streets, though the flat blocks bring the usual lift and landing constraints. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Full-height panels need the wall made good first, which is another trade and another timescale. Same slab run as the tops.