Worktop templating in Dagenham

Yes. Dagenham is on the patch, and the postcodes we work here are RM9, RM10. It is worked on our east London run, along with the rest of Barking and Dagenham. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Carcass heights are read individually, since legs bottoming out on concrete mean the units do not share one plane. Recorded as it is, not as it was drawn. Most Dagenham jobs are about maximising continuous run length in a small room, so we plan the sink and hob positions to leave one usable stretch of at least 900mm.

Generally good, wide estate roads, front gardens, hardstanding and free parking on most streets, though the flat blocks bring the usual lift and landing constraints. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The template records it along with everything else.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.