Worktop fabrication in Eastcote

Yes. Eastcote is on the patch, and the postcodes we work here are HA5, HA4. It is worked on our west London run, along with the rest of Hillingdon. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the roof has been converted there is usually a steel over the kitchen that went in after the walls, and the run beneath it is worth checking for square. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Every join over a gable, clear of every cut-out. Seating overhangs past 300mm need steel flat bar or a ply subframe, because the 20mm engineered stone people ask for will not cantilever on its own.

Wide leafy roads with in-and-out drives. The Field End Road parade is the only pinch point and its bays are time-limited. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Machined to the real line. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.