Worktop templating in Finsbury Park

Yes. Finsbury Park is on the patch, and the postcodes we work here are N4. It is worked on our north London run, along with the rest of Islington. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. With a boiler and its pipework over the run you get cut-outs and a reduced clear splashback height, so measure to the boiler casing rather than to the wall units.

Seven Sisters Road and Stroud Green Road are busy with bus lanes and loading restrictions, and the residential streets are permit-only with very high occupancy. Shared entrances, bikes in the hall and stairs to the first or second floor are standard on nearly every job. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

A peninsula is an island with one end tied to a run, which means the join between them has to be planned rather than allowed to happen. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.