Splashbacks and upstands in Frognal

Yes. Frognal is on the patch, and the postcodes we work here are NW3. It is worked on our central and north London run, along with the rest of Camden. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The original kitchen was a small service room, so what is there now is a knock-through and the junction between the two floors is rarely level. Mansion block kitchens are full of boxed-in soil stacks, gas risers and heating pipework, and the boxing is usually plywood or plasterboard that stops short of the ceiling, so the splashback run gets broken up by returns rather than running clean wall to wall. The wall makes that decision, not the brochure. Full-height splashbacks and island returns mean batch-matching matters more here than access does, so reserve slabs from one block and lay them out before cutting.

Wide but steep roads with in-and-out drives, so vehicle access to the door is usually good and the constraint is the long gravel drive and the steps up to the entrance rather than the parking. A few houses have gated entrances too narrow for a long-wheelbase van. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. The joint to the worktop is siliconed, never grouted. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The riser boxing must be finished in its final form and any access panel positions agreed before the template, since the stone is set out around them. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after.