Worktop design and quotation in Highgate

Yes. Highgate is on the patch, and the postcodes we work here are N6, N19. It is run from the Watford side, covering Hertfordshire & North London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. An island a few hundred millimetres over the usable slab length costs a whole second slab, which is worth knowing before the layout is fixed. Priced from the building, not from a rate card. On the hill the walk from where the van can legally stop to the front door is often longer than the kitchen itself, so plan the lift and the carry order before anything comes off the vehicle.

Very steep approach roads, narrow lanes parked both sides, and conservation-area frontages that sit close to the pavement with no lay-by. Several of the mansion blocks are walk-ups with a communal stair that turns twice before the first floor. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send the island size including the overhang and which side people sit at, the stool count, and confirm the edge profile you want and which edges are to receive it. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.