Kitchen worktops in Knight's Hill

Yes. A mix of interwar semis with rear kitchens that get modest extensions and postwar estate flats with fixed compact layouts, so the same street can produce a 4m island kitchen and a 2.2m galley. Landlord and housing-association refits with standard carcasses make up a steady share of the work. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged.

Interwar semi, Postwar estate housing, Victorian terrace and 1970s low-rise flat. Wider halls make the carry noticeably easier, and that alone can remove a join that a narrower terrace would have forced into the run. We measure the front door, the hall width and the turn into the kitchen before anything comes off the van, because a 3m piece has to swing through that corner on edge and stone does not bend to help you. That is the shape of the day.

Estate sections have parking courts set back from the entrances and stair-only access in the low-rise blocks, while the semis have driveways and easy approaches. Hilly ground means some parking bays sit well below the front doors they serve. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The fitting day is planned backwards from that point, before anything comes off the van. It gets checked before the first piece is lifted.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. On housing-association refits the carcasses are supplied to a fixed spec, so the top has to work to their unit heights and cutout positions rather than to what suits the stone.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Same slab run as the tops. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.