Worktop templating in Marylebone

Yes. Marylebone is on the patch, and the postcodes we work here are W1U, W1G, W1H. It is worked on our central London run, along with the rest of Westminster. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are full of boxed soil stacks, gas risers and heating pipework, and the boxing usually stops short of the ceiling. Mansion-block kitchens usually have a serviced riser or boxed pipework somewhere in the run, and the boxing is rarely the same depth from one end to the other, so the template takes the depth at worktop height at several points rather than one reading. Recorded as it is, not as it was drawn. Estate leases restrict altering the layout, so you are usually working to exactly the same run positions as the old top - keep the old worktop as a reference until the new one is in.

Portered mansion blocks with a set of house rules - works hours typically 9 to 5 weekdays only, no weekends, lift protection mandatory, and the porter controls when you can bring materials through the front hall. Original lift cars will not take a full slab. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Boxing and riser casings built, cased and finished to their final surface, units fixed and levelled, and building access, lift booking and porter arrangements agreed so both the template visit and the later fit can run. Access in a tenanted flat depends on the tenant, so the template and fitting dates are agreed with whoever actually holds the keys. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.