Worktop templating in Newbury Park

Yes. Newbury Park is on the patch, and the postcodes we work here are IG2. It is run from the Essex side, covering Essex & East London. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the laser has to be shot across the whole opening from one datum. No stone is ever cut from a plan. Because the side door and the passage are still in use, we can usually take a full slab straight to the back of the house here — one of the easier parts of the borough to work in.

Straightforward. Wide roads, most houses have a dropped kerb and a front hardstanding, and there is a proper side gate to the rear so nothing has to be carried through the house. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

With three walls in play the chance of one of them being out of square is high, and the template has to carry all three angles. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Alcove pieces get cut oversize on both scribe edges, with the true wall angles carried on the template drawing rather than assumed. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.