Worktop fabrication in Roxbourne

Yes. Roxbourne is on the patch, and the postcodes we work here are HA2. It is worked on our north west London run, along with the rest of Harrow. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. The kitchen is usually a small square or L-shaped room reached through a narrow entrance lobby and a standard internal doorway, so the limit on piece length is the turn out of the lobby, and short runs mean joins are often avoidable altogether if the layout is nested tightly. The bench proves it before the van moves. Uniform stock means a template from one house nearly fits the next, but never assume it, because 1930s builders varied the back-door corner by an inch or two.

Uniform estate roads with drives on many houses and consistent side gate widths, which makes access predictable; maisonette blocks need a shared external stair and a two-person lift up. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.