Worktop templating in Balham

Yes. Balham is on the patch, and the postcodes we work here are SW12. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. In the mansion blocks the original galley walls are solid brick and out of plumb top to bottom, so the upstand needs scribing separately from the worktop back edge.

The High Road is a bus corridor with no standing, and the residential streets either side are permit-controlled with heavy parking pressure. Converted flats above ground level are reached by a communal stair with a half-landing and often a fire door at the top that has to come off its hinges. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Appliances on site, not on order.