Worktop templating in Colliers Wood

Yes. Colliers Wood is on the patch, and the postcodes we work here are SW19, CR4. It is run from the New Malden side, covering South West London & Surrey. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Piece size is set by the lift car and the entrance dogleg, which routinely turns a two-piece kitchen into a three-piece one. The template records that corner as it is, so the mitre closes tight instead of being cut to a theoretical 90 degrees. No stone is ever cut from a plan. Developer kitchens here are built to a tight 600mm module with the sink already cut into a fixed position, so measure the existing cutouts before quoting a straight swap.

The new blocks have loading bays and a goods lift but both need booking with the concierge and there is a hard time limit on the bay. The older terraces sit on streets that back onto the river and industrial units, so vans get boxed in by delivery traffic on the A24. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.