Worktop templating in Ealing Common

Yes. Ealing Common is on the patch, and the postcodes we work here are W5. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. Two to three hours, once the units are in. Those front steps mean every piece gets lifted over three or four risers, which is worth two extra hands rather than trying it with one.

Streets around the common are residents-only permit bays. Villas have deep front paths and a flight of steps up to a raised ground floor, and driveways are rare. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.