Kitchen worktops in East Ham

Yes. The typical job is a rear-extended Edwardian terrace where the kitchen has been pushed the full width of the plot, giving a 3.5m to 4m run plus a central island of about 1.8m by 0.9m. Households are often large, so double sinks, two ovens and a lot of continuous worktop are common asks. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. It is why the arrival time is what it is.

Edwardian terrace, interwar terrace and loft-converted family house. A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. That is what the itemised lines are for.

Long straight residential roads with permit bays and some crossovers, so you can generally get a van reasonably close, but side alleys between the houses are gated and often too narrow to pass a 700mm slab on the flat. Where there is no side access the piece comes through the front door and the hallway dogleg. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. That is why the fitting line on a quote reflects manpower and time rather than square metres. It appears as its own line rather than buried in a rate.

Worktop installation, worktop templating and worktop design & quotation, in that order. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Extended kitchens here regularly need a three-piece top with two joints, and the joints want to land away from the sink and hob cut-outs.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.