Worktop design and quotation in Edgware

Yes. Edgware is on the patch, and the postcodes we work here are HA8. It is run from the Watford side, covering Hertfordshire & North London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is usually a rear room extended into the garden, with the original external wall now standing inside the run. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one — short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. Priced from the building, not from a rate card. Two sinks and two hobs in one run leaves very little solid material between cut-outs, so the piece needs rodding or a repositioned joint to survive transport.

Wide 1930s roads with driveways and clear side access on most houses, though a lot of side alleys have been filled by side extensions. Around the station and the shopping centre, loading is restricted and multi-storey height barriers rule out taller vans. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. Send photographs of every corner of the room and it gets priced properly first time. Photographs are worth more than a plan here. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Nothing payable until template.