Worktop templating in Fulham Broadway

Yes. Fulham Broadway is on the patch, and the postcodes we work here are SW6. It is run from the New Malden side, covering South West London & Surrey. The practical answer is to check the fixture list before the date is offered, because a template slot lost to a road closure cannot be recovered that week. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Working hours are constrained by the business underneath, so noisy work has a window rather than a day. Runs commonly finish at a doorway, and the architrave and skirting stand proud of the plaster, so the end of the top is notched or stopped on the drawing. Recorded as it is, not as it was drawn. Never book an install on a home matchday - the road closures alone will cost you the slot, never mind the parking suspension.

Matchdays at the ground bring road closures, parking suspensions and a controlled crowd zone across the surrounding streets, which makes a fit day there effectively impossible - check the fixture list when booking. On normal days the side streets are permit-controlled and the flats above the parades are up a single narrow street-door stair with a sharp turn onto the landing. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Where the owner is not local, the decisions happen remotely, so photographs and a clear itemised drawing carry more weight than a showroom visit ever would. The template happens when the units are in, fixed and level, whoever is fitting them. Appliances on site, not on order.