Worktop fabrication in Gants Hill

Yes. Gants Hill is on the patch, and the postcodes we work here are IG2. It is worked on our east London run, along with the rest of Redbridge. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is usually a rear room extended into the garden, with the original external wall now standing inside the run. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Settled on the drawing, cut once. Where a kitchen is being split into meat and dairy sides, the seam positions and the extra sink cut-outs need agreeing at template, it is not a job to guess at.

Broad suburban roads with in-out or single drives on most houses, so the van gets onto the property and the carry is short and level. Side access is usually gated but wide. Where the parking court sits behind the block the carry crosses open ground and gets boarded, because loaded trolleys and block paving do not agree. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.