Worktop templating in Hendon

Yes. Hendon is on the patch, and the postcodes we work here are NW4. It is run from the Watford side, covering Hertfordshire & North London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Permitted works hours are commonly weekdays with a late start and an early finish, so a one-day fit is planned around the porter and the lift. Boxing depth is taken at worktop height at several points, because measuring it low down is why a top will not sit back. Recorded as it is, not as it was drawn. Mansion block lifts are the limiting factor, and where a slab will not fit the lift a stone staircase carry needs proper protection to the treads and the handrail.

Suburban streets with drives on the semis, but the mansion blocks have narrow original lifts, half-landings and stone communal stairs, and parking around Hendon Central and Brent Street is tight through the day. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Boxing and riser casings built, cased and finished to their final surface, units fixed and levelled, and building access, lift booking and porter arrangements agreed so both the template visit and the later fit can run. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.