Worktop fabrication in Maze Hill

Yes. Maze Hill is on the patch, and the postcodes we work here are SE10, SE3. It is worked on our south east London run, along with the rest of Greenwich. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. The bench proves it before the van moves. Flat conversions here often put the kitchen on the first or second floor with no lift, so pricing has to reflect a stair carry rather than a doorstep drop.

The hill is the problem, steep gradients up from the park gate, few dropped kerbs, and long paths behind front railings, so a two-man carry uphill on wet steps needs planning. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop templating and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.