Worktop replacement in Rippleside

Yes. Rippleside is on the patch, and the postcodes we work here are IG11. It is worked on our east London run, along with the rest of Barking and Dagenham. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Half-landings mean the back of the house sits at a slightly different level from the front, and a knocked-through kitchen crosses that line. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Units kept, surface changed, one day. We do not unload on Ripple Road itself, the job gets planned around a side street, which sometimes adds a hundred metres to the carry.

Busy through-roads with red-route style restrictions on stretches, plus commercial traffic, so unloading has to be quick and off the main road wherever possible. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop splashbacks & upstands and worktop installation. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. It is the usual surprise, and it is a known one. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. Quartz is the sensible default in a rental: nothing to seal, nothing to maintain, and nothing an incoming tenant needs briefing on. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.