Worktop design and quotation in Rotherhithe

Yes. Rotherhithe is on the patch, and the postcodes we work here are SE16. It is run from the New Malden side, covering South West London & Surrey. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A two-up two-down has a kitchen that was never designed to be one, so the run is short, the ceiling is low and every millimetre of depth gets argued over. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length — anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. You see it before you commit to anything. The listed and near-listed cottages have low ceilings and doorways under 1.9m, so pieces have to be sized to turn through the hall rather than to suit the kitchen alone.

Rotherhithe Street is a long single-carriageway loop with restricted kerbside and gated riverside courtyards, and the Rotherhithe Tunnel has height and width limits that rule out anything larger than a transit coming in from the north side. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. Send photographs of every corner of the room and it gets priced properly first time. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Every line has a reason next to it.