Kitchen worktops in Southgate

Yes. Classic 1930s semis where the original kitchen and rear reception get knocked into one, producing a long L with a peninsula acting as the divider between cooking and eating. The bay window in the back room limits how far the run can travel, so most jobs land at 3.2m plus a 1.6m peninsula. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew.

1930s Metroland semi, art deco flat and 1960s block. The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the whole opening has to be shot across from one datum. Two to three hours, once the units are in.

Southgate Circus is a busy roundabout with a one-way feed and short-stay bays only, so town-centre flats need an early slot. The residential streets off Chase Side and Bourne Hill are fine but slope enough to matter with a trolley. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Worktop replacement, worktop templating and worktop installation, in that order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. The 1930s stock has original quarry-tile or screed floors that are rarely flat across a 5m span - level the run end to end, not cabinet by cabinet.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.