Worktop design and quotation in Wormholt

Yes. Wormholt is on the patch, and the postcodes we work here are W12. It is worked on our west London run, along with the rest of Hammersmith and Fulham. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rear access through a garden or a shared path means long pieces can usually come in whole from the back. Templating, fabrication and fitting are the same day's work whether the kitchen is five square metres or eight, so on a small kitchen they are a larger share of the total, and one slab covers the lot, which makes the material band the main lever you actually control. You see it before you commit to anything. The retained nib of the old back wall is where these kitchens want a mitre, and getting that internal corner tight is what the job is judged on.

Estate layout with front gardens, low walls and gates, and reasonably wide streets, so vehicle access is easier than most of W12 - the constraint is the narrow original front door and a hall barely 900mm wide. Some properties still have the original side alley to the garden, which is the better route if the gate can come off its hinges. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Written to be read by whoever is paying.