Worktop fabrication in Balham

Yes. Balham is on the patch, and the postcodes we work here are SW12. It is worked on our south west London run, along with the rest of Wandsworth. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Every join over a gable, clear of every cut-out. In the mansion blocks the original galley walls are solid brick and out of plumb top to bottom, so the upstand needs scribing separately from the worktop back edge.

The High Road is a bus corridor with no standing, and the residential streets either side are permit-controlled with heavy parking pressure. Converted flats above ground level are reached by a communal stair with a half-landing and often a fire door at the top that has to come off its hinges. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.