Splashbacks and upstands in Battersea Park

Yes. Battersea Park is on the patch, and the postcodes we work here are SW11. It is worked on our south west London run, along with the rest of Wandsworth. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The lift is a small passenger car with a gate, and the alternative is a stone stair winding round the shaft with a turn at every half-landing. Each return needs its own piece with a mitred or butted external corner, and those pieces should come off the same slab so the movement lines up across the corner. The wall makes that decision, not the brochure. Peninsulas set into a structural opening need the finished opening measured after the steel is cased, because the casing adds 40 to 60mm each side that the architect's drawing ignores.

Mansion blocks have wide communal stairs but many have no lift or only a small original passenger lift, and porters restrict working hours. Flat entrance doors are often original and narrower than the corridor suggests. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Same batch, same run, same day. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. The riser boxing must be finished in its final form and any access panel positions agreed before the template, since the stone is set out around them. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. The wall has to be ready.