Worktop replacement in Clapham Junction

Yes. Clapham Junction is on the patch, and the postcodes we work here are SW11. It is worked on our south west London run, along with the rest of Wandsworth. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. It is a full day at the kerb, not a delivery. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

For the above-shop flats plan on two shorter pieces with a deliberate joint at the sink rather than one long top, because the stair simply will not take the length.

This is one of the worst spots in the borough for standing a van, bus lanes, red route sections, and constant traffic around the station. Above-shop access is by a shared street door and a long steep stair with a landing turn at the top. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop splashbacks & upstands and worktop fabrication. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Empty the base units completely and have a plumber disconnect the sink, tap and any washing machine plumbed in under the worktop before we arrive. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A plumber disconnects before we arrive and reconnects after we leave, and that is worth booking early. Plumber either side of us.