Worktop fabrication in Cranham

Yes. Cranham is on the patch, and the postcodes we work here are RM14. It is worked on our east London run, along with the rest of Havering. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls look modern and are not: block or breeze with a skim that has been patched over decades, so dry-laying and scribing still apply. These have a back door straight into the kitchen so getting pieces in is rarely the issue, but the room is small and the runs are short, which puts the sink, hob and tap cut-outs close together on a single length of stone. The bench proves it before the van moves. Existing floors are usually staying here, so we protect them properly and check base-unit heights against the finished floor rather than the slab.

Very easy: wide estate roads, individual drives, garages, turning space and no parking restrictions to speak of. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop design & quotation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. Final appliance positions and the actual sink and hob need to be settled before machining, because on a run this short a few centimetres of movement decides whether the piece can be cut in one. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.