Worktop fabrication in Furzedown

Yes. Furzedown is on the patch, and the postcodes we work here are SW17, SW16. It is worked on our south west London run, along with the rest of Wandsworth. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Every join over a gable, clear of every cut-out. Where a utility is partitioned off, the two rooms usually want the same material but different thicknesses, confirm which side takes the offcuts before the slab is laid out.

The area sits inside a loop of main roads with limited through routes, so satnav approaches often fail and the van has to come in from Mitcham Lane or Tooting Bec Road. Once inside, parking pressure is moderate and most houses have a front path. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Machined to the real line. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.