Worktop replacement in Gascoigne

Yes. Gascoigne is on the patch, and the postcodes we work here are IG11. It is worked on our east London run, along with the rest of Barking and Dagenham. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Concrete panel walls bow noticeably over the length of a run, so the template picks up the real line and the back edge is cut to follow it. Plaster bonded straight onto concrete comes away with the bottom course of tiles, leaving a band behind the upstand. Units kept, surface changed, one day. Fire doors and 90-degree landings are the real limit on flat jobs here, so lengths are cut to what will physically turn on the landing.

Flats above ground level throughout, so it is lifts, communal stairs, narrow landings and fire doors, with delivery times often restricted by the managing agent. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop templating and worktop splashbacks & upstands. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Sort a parking bay or permit near the entrance, confirm the lift is in service and get us the door codes, and tell us about any asbestos survey on the flat before we start stripping out. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.