Worktop templating in North Harrow

Yes. North Harrow is on the patch, and the postcodes we work here are HA2. It is run from the Watford side, covering Hertfordshire & North London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. The typical 1930s kitchen sits at the back with a low window over the sink run, so the template records the exact sill height above the units to settle whether an upstand fits or the stone has to die into a window board. No stone is ever cut from a plan. Straightforward stock, so the constraint is usually the retained 1930s window cill height dictating whether a 20mm or 30mm top fits under it.

Wide roads with grass verges, dropped kerbs and driveways on most houses, and side gates typically wide enough to take a slab down the side to a rear extension without going through the house. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Appliances on site, not on order.