Worktop templating in Peckham

Yes. Peckham is on the patch, and the postcodes we work here are SE15. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. Half these jobs land mid-build with the extension still drying out, so template late and check the plaster is on before you cut.

Tight terraced streets with permit bays, a lot of skips and builders' vans competing for kerb, and rear access rarely usable because gardens back onto other gardens rather than a lane. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.