Worktop fabrication in Pinner

Yes. Pinner is on the patch, and the postcodes we work here are HA5. It is worked on our north west London run, along with the rest of Harrow. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lime plaster over rubble moves in and out enough that a single long panel will show a gap somewhere along its length. The joins here are chosen rather than forced, so they go where the veining and the gables want them. Settled on the drawing, cut once. In the old village houses nothing is straight and the ceiling may be lower than the slab is long, so check whether the piece can be tilted upright inside the room before it comes off the van.

The High Street and the lanes around it are narrow, sloping and heavily restricted with limited loading windows, so village jobs need an early slot; the surrounding suburban roads have proper driveways and no such problem. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop design & quotation and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.