Splashbacks and upstands in Stanmore

Yes. Stanmore is on the patch, and the postcodes we work here are HA7. It is worked on our north west London run, along with the rest of Harrow. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. The ragged band left when old tiles and laminate come off together is what usually decides upstand over full height. The wall makes that decision, not the brochure. Separate meat and dairy runs mean planning two identical worktops from the same batch so the colour matches across the room, and that is a slab reservation decision, not a fitting decision.

Long gravel or block-paved driveways with gates and often a turning circle, so vehicles get very close, but the internal carry from the front door to the rear kitchen can be 15m or more with a hallway turn. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The returns into a breast recess are the tightest scribes in the room, and they are eased in rather than forced. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. The old tiling must be off and the wall made good and dry before templating, not on fitting day. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Full-height panels need the wall made good first, which is another trade and another timescale. Same slab run as the tops.