Worktop templating in Thamesmead

Yes. Thamesmead is on the patch, and the postcodes we work here are SE28, SE2. It is run from the New Malden side, covering South West London & Surrey. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Rear access through a garden or a shared path means long pieces can usually come in whole from the back. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the laser reads the top of every carcass rather than assuming they share a height. Two to three hours, once the units are in. Fixing into precast concrete needs the right anchors and serious dust control — nothing here takes a plasterboard fixing.

Raised pedestrian decks, podium levels and garage undercrofts mean the front door is often nowhere near where the van can park, and some blocks are reached only by a walkway or a small lift. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a partition has been built off the floor screed rather than off the slab, it moves, and a mitre bonded across that corner is the first thing to open. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Appliances on site, not on order.