Worktop fabrication in West Wickham

Yes. West Wickham is on the patch, and the postcodes we work here are BR4. It is worked on our south east London run, along with the rest of Bromley. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A detached house of this age has a drive, a side path and a back door, so access is rarely the constraint and the design can follow the room. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Settled on the drawing, cut once. The repeated 1930s footprint means the island rarely sits square to the original walls once the extension goes on, so the island is set off the new steels, not the old wall line.

Good driveways and dropped kerbs on most roads, though the semis have a shared drive on some streets where you have to co-ordinate with the neighbour before blocking it. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.