Splashbacks and upstands in Becontree Heath

Yes. Becontree Heath is on the patch, and the postcodes we work here are RM8, RM10. It is worked on our east London run, along with the rest of Barking and Dagenham. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. That suits a full-height piece, because a large flat panel bonded across its back is more stable on concrete than a run of small tiles ever was. Cut from the same slab run as the tops. The private 1930s semis here have deeper rooms than the estate houses next door, so we do not assume the standard Becontree layout when quoting.

Main roads through here are busy and junction-heavy, but the side streets have driveways, dropped kerbs and side gates, so the actual unloading is usually done off the main route. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Scribed, dubbed out, or set proud. Pick one. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. The wall has to be ready.