Splashbacks and upstands in Brondesbury

Yes. Brondesbury is on the patch, and the postcodes we work here are NW6, NW2. It is worked on our north west London run, along with the rest of Brent. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range sitting in a chimney recess is common, and the flanking pieces are cut with the manufacturer clearance built into the template. Long runs mean more than one piece, and the joint belongs in a corner or on a hob centre line rather than mid-run. Decided before fabrication starts. Chimney breasts and boxed-in stacks mean two shallow returns instead of one clean run, and the template has to record the actual out-of-square rather than assume 90 degrees.

Steep front steps up to raised ground floors on the villas, converted flats on first and second floors reached by the original staircase, and permit parking that fills by mid-morning. There is rarely any off-street space. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. Where the wall cannot be made good, setting the stone deliberately proud on a subframe with a shadow gap reads as a detail rather than a bad fit. Make the wall good first, or accept the detail. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Full-height panels need the wall made good first, which is another trade and another timescale. The wall has to be ready.