Worktop fabrication in Fortis Green

Yes. Fortis Green is on the patch, and the postcodes we work here are N10, N2. It is worked on our north London run, along with the rest of Haringey. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The bay at the front and the back addition at the rear were built to different standards, and the kitchen is nearly always in the weaker of the two. Pieces are sized to the tightest turn on the route before anything is nested to the slab. Every join over a gable, clear of every cut-out. The interwar estate houses have shallow 550mm base units in places - check the depth before ordering, a standard 620mm top leaves a bigger overhang than the client expects.

Fortis Green road itself is narrow with parking both sides and a constant flow of buses, so unloading is a two-minute job then move the van. The estate streets are flatter and easier than the rest of N10. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.