Kitchen worktops in Harold Wood

Yes. Inter-war semis around the station taking the usual knock-through into the dining room, alongside a substantial modern development on the old hospital grounds where the houses and flats arrived with builder-standard kitchens now coming up for their first upgrade. The new-build kitchens are well-proportioned but the units are shallow, so the top overhang has to be set carefully. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap.

1930s semi, Edwardian terrace, post-war semi and 2010s new-build on the former hospital site. The chimney breast in the corner has usually been left in place, so the run gains a return and two scribed ends. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question.

Older streets have drives and dropped kerbs; the new development has narrow shared-surface roads, allocated bays and parking enforcement, so we book a slot rather than assume a space. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop templating, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. One visit, done properly. New-build carcasses on the modern estates are often lightweight and not designed for stone, so we brace and level them before loading a 20mm slab onto them.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.