Worktop installation in Harold Wood

Yes. Harold Wood is on the patch, and the postcodes we work here are RM3. It is worked on our east London run, along with the rest of Havering. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day. New-build carcasses on the modern estates are often lightweight and not designed for stone, so we brace and level them before loading a 20mm slab onto them.

Older streets have drives and dropped kerbs; the new development has narrow shared-surface roads, allocated bays and parking enforcement, so we book a slot rather than assume a space. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. None of it is worked out on the doorstep.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The fitting day is arranged with whoever can actually give us access for the whole slot. Access for the whole slot, or a different day.