Splashbacks and upstands in Millwall

Yes. Millwall is on the patch, and the postcodes we work here are E14. It is worked on our east London run, along with the rest of Tower Hamlets. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These buildings have firm rules about what can be propped open, left in a lobby or carried through the residents entrance. The plasterboard is genuinely flat here, so a full-height splashback sits well and a slim upstand looks almost redundant, but the sockets are the problem, because they are set out to the developer's original kitchen and often land at odd heights or right on a joint line. Cut from the same slab run as the tops. Structural columns in the middle of opened-up flats are common, and a top that has to notch round one needs the column dimensions taken at template, not from a plan.

Blocks sit around the dock edge with restricted vehicle access to the water side, meaning the van parks at the road frontage and the slab is walked round the dock path. Many buildings are gated with a single narrow lift and a step-up threshold at the lobby door. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Where the route is tight we break a long splashback at a natural vertical joint instead of forcing one panel through. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop replacement and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. Where the wall cannot be made good, setting the stone deliberately proud on a subframe with a shadow gap reads as a detail rather than a bad fit. Make the wall good first, or accept the detail. Any socket you intend to move must be moved and re-plastered before templating, because a cut-out in the wrong place means a new piece of stone. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.