Worktop fabrication in Summerstown

Yes. Summerstown is on the patch, and the postcodes we work here are SW17. It is worked on our south west London run, along with the rest of Wandsworth. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Wider halls make the carry noticeably easier, and that alone can remove a join that a narrower terrace would have forced into the run. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. New-build peninsulas here are fixed to a plasterboard-clad frame rather than solid cabinets, so the overhang needs brackets or a sub-frame rather than relying on the carcass.

Industrial estates and the river restrict the road network, and lorry traffic on Garratt Lane and Plough Lane makes stopping difficult at peak times. The new blocks have booked loading and a service lift; the old terraces have on-street permit bays only. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Pieces are dry-assembled and checked on the bench before anything is loaded. Nested for the job in front of us.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Machined to the real line. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.