Worktop fabrication in Hampton Wick

Yes. Hampton Wick is on the patch, and the postcodes we work here are KT1. It is worked on our south west London run, along with the rest of Richmond upon Thames. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Floors are suspended timber over a shallow void and have moved, so the units are packed and levelled before anything is set on them. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Every join over a gable, clear of every cut-out. Doors opening straight onto the street mean the slab goes from tailgate to threshold in one move, so the van has to be right at the door or the job stalls.

The village sits at the foot of Kingston Bridge, so traffic queues through it most of the day, the streets are narrow with residents' bays, and many cottages open straight onto the pavement with no front garden to stage the load in. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. Internal corners are machined with a radius and polished, and kept well clear of any join or cut-out. Radiused, polished, and clear of the joins. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. The approved drawing is the instruction.