Worktop fabrication in Peckham Rye

Yes. Peckham Rye is on the patch, and the postcodes we work here are SE15, SE22. It is worked on our south east London run, along with the rest of Southwark. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. The joins here are chosen rather than forced, so they go where the veining and the gables want them. Settled on the drawing, cut once. One of the few places nearby where a 3m single piece genuinely fits through the front door, so the joint decisions are aesthetic rather than forced.

Roads around the common are wide enough to unload but are controlled parking with residents' bays; front paths are long with a step up, and the double-fronted houses have a generous hall that takes a full piece without drama. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. So the nesting is planned around it rather than around a standard kitchen. Nested for the job in front of us.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Pieces are dry-assembled on the bench before dispatch so the corners are known to close before they leave the workshop. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. The drawing decides it, not the fitter. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Dry-assembled before it leaves.