Kitchen worktops in Bow Common

Yes. Small kitchens dominate, mostly 2m to 2.5m single runs in maisonettes and low-rise flats, with washing machine and boiler both fighting for the same corner. The newer infill houses have a slightly larger L-shape opening onto a dining area. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three.

post-war council estate, 1980s infill housing and recent gasworks-site apartment block. An infill house is built to modern standards on an old plot, so the room is square even though the site around it is not. The plasterboard is genuinely flat here, so a full-height splashback sits well and a slim upstand looks almost redundant — but the sockets are the problem, because they are set out to the developer's original kitchen and often land at odd heights or right on a joint line. The wall makes that decision, not the brochure.

Wide estate roads and open parking courts make the physical unload easy, but bollards and locked gates between courts mean the shortest route on a map often is not open. The 1980s infill houses have a straight run from front door to kitchen, which is a rare thing round here. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Boilers and gas meters are frequently mounted in the run, so cut-outs and clearances need agreeing on site before anything is fabricated.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. The template happens when the units are in, fixed and level, whoever is fitting them. Appliances on site, not on order. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.