Splashbacks and upstands in Tollington

Yes. Tollington is on the patch, and the postcodes we work here are N4, N7. It is worked on our north London run, along with the rest of Islington. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear wall is usually a single brick thick and has been rendered, patched and re-rendered, so it bows in and out along the length of the run. A 100mm upstand bedded on silicone is the honest answer where the plaster bows, because it rides what a tall panel exposes. Cut from the same slab run as the tops. A knock-through joins two rooms with different ceiling heights and wall finishes, so batch-match the slabs and set your level off the longer span rather than the shorter one.

The streets between Hornsey Road and Seven Sisters Road are narrow, one-way in places and permit-only, while the main roads either side carry buses with loading limits. Straight halls with a rear door make the carry manageable once the van is parked. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Siliconed to the worktop, never grouted. Batching several kitchens together is the one situation where buying a whole slab is cheaper per kitchen rather than more expensive. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.