Kitchen worktops in Charville

Yes. Ex-local semis and terraces largely on their original footprint, runs of around 2.7m with the back door in the corner, and refits driven by landlords and first-time buyers rather than designers. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised.

1930s estate semi, postwar terrace and ex-local housing. Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. The plaster is bonded straight onto the concrete, so the bottom course of tiles tends to bring plaster with it when the old top comes off, leaving a rough band behind the upstand. Units kept, surface changed, one day.

Wide estate roads with grass verges and paved hardstanding, no restrictions, and you can generally park directly outside the door. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Worktop replacement, worktop installation and worktop splashbacks & upstands, in that order. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The carcasses have to be sound, because stone is several times the weight of what is coming off. Sound carcasses or it does not go ahead. Original mid-century base units are 500mm deep, so a modern 600mm top overhangs badly and you either replace the carcasses or accept a large front oversail.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. The joint to the worktop is siliconed, never grouted. A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The back edge is eased in progressively rather than offered up once and forced. It is the slow part of the day and it should be. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Plumber either side of us. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.